Blade installation
The fan blades come in A/B variants with distinct front and back sides: the small white LED light is located on the front side, while the square chip is on the back side. The back side of the fan blade allows you to identify whether it is the A or B blade. Install the A blade into the A card slot and the B blade into the B card slot by pressing the latches on both sides of the card slots downward with two fingers, then fully insert the blades until you hear the latches snap back—this confirms correct installation.
Wall-mounted installation method
The black T-shaped pendant features a small screw hole at its top. To secure the pendant correctly, ensure the screw hole faces upward. Then, use screws from the central or side holes of the pendant to fasten it to the back panel. Next, secure the device vertically downward using the rear buckle, and finally tighten the small black screws inside the screw pack to fix the pendant's upper screw hole.
power supply mode
The device comes with a built-in 110–220V adapter, allowing direct plug-and-play operation. It is compatible with all standard national voltage levels.
Use of Supporting Software
Use the QR code or website to download the device app on your phone or computer. Once the device is properly installed and powered on, a local WiFi network will be available. Connect to this WiFi, open the app, and the video list will appear, indicating a successful connection. You can then control the device by turning it on/off, switching channels, or uploading videos and images.